Operating Instructions; Switching The Unit On/Off; Timer Setting; Sleeping Mode - ecofort ecoQ DryAir 13L Energy Saver Manuel D'utilisation

OPERATING INSTRUCTIONS

Note:
•
Ensure the supply power is in correspondence with the value on the nameplate.
•
Ensure the water tank is correctly fitted before the dehumidifier can be switched on.
•
If the dehumidifier is turned off and then turned back on again immediately, it will take
approximately 3 minutes to reach full power (compressor back to work).
•
If the dehumidifier is switched off by a power cut, it will automatically switch back on once
the power is restored.
•
The dehumidifier works best at normal room temperature, its efficiency is reduced if the
ambient temperature falls below 15 °C.

Switching the Unit On/Off

Connect the mains lead to power socket.
Press power button once to turn on the unit. By default, it runs on Manual Dehumidifying Mode.
Press Power button once again to turn off the unit.
Humidity Setting Control
Press Manual button once to enter Manual Dehumidifying Mode or to select desired level of
humidity from CO-30%-35%-40%-45%-50%-55%-60%-65%-70%-75%-80%-CO
Note: If ambient humidity is lower than 30%, display shows LO.
If ambient humidity is higher than 90%, display shows HI.

Timer Setting

In ON Mode, press timer button consecutively to select your preferred timer duration for automatic
shutoff setting. Its corresponding Timer indicator will be displayed on screen.

Sleeping Mode

In Manual Mode, press Sleeping Button once to enter Sleeping Mode. Its corresponding Sleeping
indicator will be displayed on screen, 10 seconds later, other indicators will be off. In Sleeping Mode,
it operates in low fan speed.
Note: In Sleeping Mode, press any button to wake up the unit first then to operate as usual.
49