Operating Instructions; Timer Setting - ecofort ecoQ DryAir 20L Energy Saver Manuel D'utilisation

OPERATING INSTRUCTIONS

Note:
Ensure the supply power is in correspondence with the value on the nameplate.
·
Ensure the water tank is correctly fitted before the dehumidifier can be switched on.
·
If the dehumidifier is turned off and then turned back on again immediately, it will take
·
approximately 3 minutes to reach full power (compressor back to work).
·If the dehumidifier switched off by a power cut, it will automatically switch back on once the
power is restored.
The dehumidifier works best at normal room temperature, its efficiency is reduced if the
·
ambient temperature falls to below 15 ° C.
Switching On/Off the Unit
Connect the mains lead to socket.
Press Power button once to turn on the unit. By default, it runs on Manual Dehumidifying Mode.
Press Power button once again to turn off the unit.
Humidity Setting Control
Press Manual button once to enter Manual Dehumidifying Mode or to select desired level of
humidity from CO-30%-35%-40%-45%-50%-55%-60%-65%-70%-75%-80%-CO.
Note: if ambient humidity lower than 30%, display shows LO.
if ambient humidity higher than 90%, display shows HI.

Timer Setting

At ON mode, press Timer button consecutively from 1-24h to select your preferred timer
duration for automatic shutoff setting. Its corresponding Timer indicator will be displayed on
screen.
58