Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - shark Rocket HV300 Guide Du Propriétaire

MAINTAINING YOUR VACUUM

IMPORTANT: Clean the dust screen
inside the dust cup as required�
NOTE: Empty dust cup when debris
reaches the MAX fill line�
13
s h a r kc l e a n . c o m
Empty

EMPTYING THE DUST CUP

1
Press the Wand Release button on
the top of the wand to disconnect it
from the handheld vacuum�
2 Position the handheld vacuum so the
dust cup is over a trash bin and press
the Empty button on the front�
The bottom lid will open, allowing
the debris to fall out�
3 Once dust cup is empty, close the
bottom lid�
RECOMMENDED FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XFFV300
Clean once a month�
Post-Motor Filter
XFFV300
Clean once a year�
IMPORTANT: If more cleaning is
needed, rinse filters with water only
and let them air-dry completely�

CLEANING THE FILTERS

1 Pre-Motor (foam and felt):
Lift the latch on the top of the
handheld vacuum to open the filter
cover� Take out filters and tap loose
dirt off them� If more cleaning is
needed, rinse filters with water only
and let them air-dry completely�
To reinstall them, insert the felt
filter first, place the foam filter on
top of it, and close the filter cover�
Foam
Felt
2 Post-Motor:
Lift off the post-motor filter cover
below the handle of the handheld
vacuum� Remove the filter, rinse it
with water only, and let it air-dry
completely� Replace the filter, then
close the cover, pressing it until it
clicks into place�
Felt
s h a r kc l e a n . c o m
14