Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
AIR TOOL PRECAUTIONS
1.
Use only clean and dry compressed air as a power source. Contaminated
or moist air will gradually damage the tool.
2.
Install an in-line shutoff valve or regulator to allow immediate control over
the air supply in an emergency, even if a hose is ruptured.
3.
Discontinue tool use if it does not work properly or air is leaking. Tag or
mark the tool as 'defective' or 'out of service' until repaired.
4.
Check the manufacturer' s maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated to never
exceed the maximum pressure rating of the tool (see Specifications).
Exceeding the maximum PSI rating can create a bursting hazard, causing
injury and property damage.
5.
Attach all accessories properly to the tool before connecting the air
supply. A loose accessory may detach or break during operation.
6.
Never use oxygen, combustible gas or any other bottled gas as a power
source. Any power source other than an air compressor could cause an
explosion and serious personal injury.
7.
Turn OFF the valve and discharge any remaining air pressure after each
use or before adjusting the tool.
8.
Do not leave the air tool unattended with its compressed air supply on.
Turn off the compressed air supply and bleed the air tool of any remaining
compressed air before leaving the air tool unattended.
9.
Serious injury may occur from loose debris being propelled at high speeds
from the compressed air stream. Always wear OSHA approved safety
glasses to protect the eyes during operation of the air compressor.
10. Always turn off the air compressor and drain tank pressure completely
before attempting maintenance or attaching air tools. Release pressure
slowly from the system.
HYDRAULIC PRECAUTIONS
DANGER! Seek immediate medical attention if hydraulic fluid under
pressure penetrates your skin. See Injection Injury precautions for
instructions before using a pressurized hydraulic system.
1.
Do not touch or handle, hydraulic hoses or components while under
pressure. Hydraulic fluid escaping under pressure has sufficient force to
Page 7
PNEUMATIC/HYDRAULIC BOTTLE JACK
www.princessauto.com / 1-800-665-8685
8668147
Publicité
Table des Matières
