Care & Maintenance - Power Fist 8668147 Mode D'emploi

8668147
1. Insert the slotted handle end over the release valve.
2. Open the valve by gradually twisting to the left. The load will begin to
lower.
3. Twist right to slow and left to increase the rate of descent.
4. Remove the jack once the load is on the ground or a support mechanism
like jack stands.
5. The ram should fully retract. If it does not, push down on it until it is
seated.
PNUEMATIC OPERATION
This bottle jack also includes a pneumatic option for raising and lowering the
load. You will need an air source to power the bottle jack.
1. Place the jack on a hard level surface capable of handling the load.
2. Connect the air inlet fitting to the shop air supply hose quick coupler, then
turn on the air valve.
3. Close the release valve.
4. Raise the load to the desired height, turn off the air valve and immediately
use jack stands with an adequate capacity to support the load.
5. When work is done, raise the load enough with the jack to carefully
remove the jack stands.
6. Then slowly and carefully lower the load by turning the release valve
counterclockwise (use the slotted end of the handle) in extremely small
increments.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components.. Only use identical replacement parts when servicing.
3. Only use accessories intended for use with this tool. Follow instructions
for changing accessories.
4. Keep the tool handles or gripping surfaces clean and dry.
www.princessauto.com / 1-800-665-8685
PNEUMATIC/HYDRAULIC BOTTLE JACK V1.0
Page 12