Assembly & Installation - Power Fist 8668147 Mode D'emploi

8668147
IDENTIFICATION KEY
A. Saddle
B. Return Spring
C. Handle Receiver
D. Air Coupler Plug
E. Trigger
F. Handle (Upper and Lower)
G. Air Motor
H. Swivel Connector
ASSEMBLY & INSTALLATION
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with your
tool.
1. Wrap the external threads of the coupler plug with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2. Screw the coupler plug into the tool's air inlet and tighten with a wrench
until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the
tool. A quick coupler may then be used to connect the leader hose to the
air line hose.
www.princessauto.com / 1-800-665-8685
PNEUMATIC/HYDRAULIC BOTTLE JACK V1.0
Page 10