Qlima Fiorina 74 S-line Manuel D'installation page 104

4
104
Figure 9A:
A. Forced draught hood
B. Wall bracket
C. Flue pipe joint
D. Double-wall pipe
E. Dual-insulated wall passage
F. T-joint with closing cap
G. Closing cap
H. Combustion air intake pipe
I. Single-wall flue pipe (can also be built in double wall)
J. Double-wall flue pipe (can also be built in single wall)
Figure 9B:
A. Forced draught hood
B. Rain protection
C. Roof support plate
D. Support plate surface
E. Flue pipe coupling ring
F. Dual insulation wall-fitted flue pipe
G. Support plate surface
H. Fireplace separation plate
I. Double-wall flue pipe (can also be built in single wall as far as the
ceiling)
J. T-joint with cap
K. Combustion air intake pipe
Figure 9C:
A. Forced draught hood
B. Rain protection
C. Roof support plate
D. Support plate surface
E. Flue pipe coupling ring
F. Concentric flue pipe
G. Support plate surface
H. Fireplace separation plate
I. Concentric flue pipe
J. T-joint with concentric cap
K. Combustion air intake pipe, the combustion air is drawn through
the concentric pipe.
Figure 9D:
A. Forced draught hood
B. Existing chimney plate shrinkage.
C. Chimney pipe to reduce the diameter of the existing chimney.
D. Coupling joint
E. Fireplace separation plate
F. Flue pipe coupling ring
G. Insulated double-wall flue pipe (can also be created with a single
wall as far as the connection to the chimney)