Μbms - Iom CWAR 01-N-3ALL Manuel D'installation Et De Maintenance

13.2. µBMS
The µBMS control module must be connected in accordance with the diagram below.
Use screened twisted pair telephone wire with a section of between 0.12 and 0.5
mm²for wiring the control modules.
Refer to the following chapter for detail of the appliances' addressing.
The use of the µBMS recall command is not compatible with the modbus communication.
The same terminals and addressing DIPs are used in both connection cases.
GND
A- B+
12V
RCL
17