Installation; Clearance; Unit Location - Iom CWAR 01-N-3ALL Manuel D'installation Et De Maintenance

9. INSTALLATION

The unit is not designed to withstand weights or stresses from adjacent equipment, pipe work or
constructions. Any foreign weight or stress on the unit structure could lead to a malfunction or a
collapse with dangerous consequences for personnel and property. In such an event, the warranty
shall be null and void.

9.1. CLEARANCE

70mm

9.2. UNIT LOCATION

The unit base shall be arranged as indicated in the manual. There could be a risk of personal injury
or damage to property in the event of the unit being incorrectly supported.
The unit must be installed on a firm level foundation, of adequate strength to support its full operating weight.
1. Install the unit in a location allowing easy removal of the filter and the access panels
to the electrical box/compressor and fan by leaving sufficient free space for servicing
personnel to perform maintenance and repairs. Leave sufficient space for the water
and electricity connections.
2. The unit must be pitched slightly towards condensate drain outlet to provide positive drainage of
condensates.
3. We recommend the installation of a siphon on the condensate outflow to avoid unpleasant odours
travelling back up the pipe.
4. All electrical and ductwork connections to the unit must be made via flexible connections to prevent
transmission of vibration.
5. In addition to the service clearances noted on the dimension sheet it is essential that provision is
made for adequate and safe service access.
The units are designed to be installed in a controlled environment. Each unit should be located on the installation
plans. Inspect the carton for specific tagging numbers and references (models, size, left hand or right hand). The
supply, return and condensation piping should be located accordingly making sure the piping will fit into the confines
of the fan coil chassis and cabinet.
70mm
70mm
8
70mm