LSL 120S091 Instructions De Montage page 3

Fitting instruction Superbike-Kit
Model: Suzuki SV 650 S
Suzuki SV 650 SA (ABS)
VIN-Code: JS1BY
Important: If you are not a trained motorcycle mechanic stop now. Ask a local
motorcycle shop to do the work for you. Please read the LSL-Superbike-Kit
Fitting instructions.
Recommended bar:
Brake hose:
Cable routing diagram:
Throttle cable (1): on the right side
of the steering head and in front of
the right slider-tube
Clutch cable (2): on the left side of
the steering head and in front of
the left slider-tube
Fairing and the fairing screen need no operation.
Instructions:
To reroute the throttle cable and wiring
harness you need to remove the seat
and lift up the fuel tank. Remove the air
box, disconnect the connector of the
handlebar controls reroute the cable over
the frame tube and connect them again.
Route the throttle cable to the right and
lead it between the frame's tubes to the
outside. Remount the air box. The wire
stay that holds the cable has to be
relocated with the supplied stay and
remounted. Mount the top yoke together
with the handlebar
controls and adjust everything to the
desired position. Mount the aluminium
washer under the top yoke. Do not drill the holes to secure the position of the controls
before adjusting everything in the desired position. Fix the reservoir as shown in the
drawing. To finish, check whether all the bolted connections are properly tightened.
LSL-Motorradtechnik GmbH • D-47809 Krefeld
Part no.: 120S091 & 120S116
Type N1 (AN1 / LN1)
76cm + 62cm (BK23)  SV 650 S
Cross-Over layout, one hose to the right calliper
and one hose from the right to the left calliper
34cm (34BH1)  SV 650 SA (ABS)
(2)
and handlebar
www.lsl.eu
Year: 2003 
Year: 2007 
Rev. 01 25/01/2010
(1)