Orbegozo CPW 02120 Manuel D'instructions page 15

CPW 02120, CPW 03120
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and to switch
the light and fan on or off.
- Replace the batteries by sliding the battery compartment cover on the remote
control transmitter in the direction of the arrow, fit 1 x A23 12v battery
(Note : Batteries NOT included).Re-assemble the battery compartment cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
- Don't attempt to recharge expired batteries. There are special rechargeable
batteries, which are clearly marked with.
- Don't dispose of batteries in fire to avoid explosion.
REMOTE CONTROLLER OPERATION:
Point the remote at the infrared sensor to power the fan.
HIGH: Drives the fan at high speed.
MEDIUM (med): activates the fan at medium speed.
LOW (low): activates the fan at low speed.
STOP (off): turns off the fan.
LIGHT: on/off: Turns the fan light on or off.
1H, 2H, 4H: programs the operation of the fan (but not the light)
for 1 hour, 2 hours and 4 hours respectively. To do this, start the
fan and press one of these 3 buttons, and after the selected time
the fan will stop working (note: the light cannot be programmed)
: press and hold to activate Wi-Fi.
Battery: 2xAAA 1.5V
15