INFORMATION
Cleaning the Filters
Replace your filters at regular intervals according
to the frequency of use. It is recommended that
you replace the filters every 6 months for average
use.
While you empty the dust accumulated in the
dust container to clean the container, you need
to clean the motor protection filter, the foam filter
and HEPA filter as well.
Warnings
Do not use appliances producing hot air such
7
as hair dryer or heater to dry the filters.
Do not install the filters without completely
7
drying them; otherwise, smell of moisture may
occur during use, water can leak from the back
of the appliance or the filters may get dam-
aged.
Attach the filters into their places after they
7
have dried.
Motor protection filter (MIF)
This filter is located on the dust container.
1
P ress the dust container removal button
remove the dust container
2
P ress the opening button for the motor protec-
tion filter (MIF) housing
3
R emove the motor protection filter by pulling it.
22
ENGLISH
__________________________________
and
B
.
E
.
H
4
A fter shaking if off, wash it under running
water, wring it out gently and leave it to dry
(for 24 hours minimum).
Foam filter
1
P ush down the rear cover opening latch to
open the cover.
2
R emove the foam filter behind the cover and
wash it.
3
A fter shaking if off, wash it under running
water, wring it out gently and leave it to dry
(for 24 hours minimum).
HEPA filter
1
P ush down the rear cover opening latch to
open the cover and remove the HEPA filter by
pulling it from its handle.
2
Y ou can wash the filter under running water
after shaking it off.
3
I f you wash the HEPA filter, dry it at room tem-
perature (for 24 hours minimum). Do not use it
before ensuring that it is completely dry.
4
F or a longer service life, you can clean the
HEPA filter by hitting it on a hard surface in-
stead of washing it. Thus the dusts accumulated
on the HEPA filter will leave the filter as you hit
it on a hard floor.
Foam filter
HEPA filter