Dell Systems PowerEdge 2800 Installation page 9

F6590bk0.book Page 7 Tuesday, July 6, 2004 4:33 PM
2
Connect the SCSI connector on the 1 x 2 backplane to the riser card or the optional RAID
controller card.
If your 1 x 2 module connects to the onboard riser card:
Connect the SCSI connector on the 1 x 2 backplane to SCSI channel A on the riser card.
a
See Figure 1-4.
Insert the SCSI cable harness into cable routing slot 1. See Figure 1-4.
b
If your 1 x 2 module connects to the optional RAID controller card:
Connect the SCSI connector on the 1 x 2 backplane to SCSI channel A (channel 0)
a
on the optional RAID controller card. See Figure 1-4.
Insert the SCSI cable into cable routing slot 2 and the cable routing slots located
b
at the bottom of cooling fan 8. See Figure 1-3.
3
Install the hard drives into the 1 x 2 module.
Figure 1-4. 1 x 2 Module and SCSI Backplane Connectors
power
connector
6-pin
connector
SCSI
connector
peripheral bay
1 x 2 module
power connector
SCSI backplane
Installing the 1 x 2 SCSI Module
1-7