Teuco HYDROSONIC - Hydrosilence 543 Manuel De L'utilisateur page 8

EN
WHIRLPOOL QUICK START
Whirlpool
ON/OFF button
LED Blinking
Indicates reception of signals from Remote Control (see
Remote Control)
WHIRLPOOL QUICK START
Once the system has been powered up, the whirlpool function can be activated by pressing a single
button at the control panel. The function maintains the settings most recently stored (see WHIRLPOOL).
To start the whirlpool, press the "HYDRO" button.
The whirlpool starts and the display shows:
• The exact time.
• The temperature of the water in the tub.
• The duration of the whirlpool session
(TIMER) in minutes.
• Whirlpool in progress.
To make adjustments, use the remote control
(see Remote Control).
When the whirlpool has finished, the system shuts
off and the display reverts to STAND-BY.
DISINFECTION of the system is not carried out
(see DISINFECTION).
To cut the session short, press HYDRO a second time or use the remote control (see Remote Control:
Preliminary Operations); the system shuts off and the display reverts to STAND-BY.
8
Display
Shows messages
Infrared receiver
15 36 C 20:30
o
whirlpool
Display indicating Whirlpool
in progress
20:30
Display indicating STAND-BY
status
HYDROSONIC - Hydrosilence
ALARM
ON/OFF button