GYS Powerduction 110LG Mode D'emploi page 15

Translation of the original instructions
Switch setting
1
2
3 et 4
5
6
7 et 8
OPERATION WITH PYROMETER ANALOG OUTPUT (not supplied)
Use a pyrometer sensor with an analog output directly on the product connectors (to be adapted according to the
datasheet of the pyrometer used)
Example of a current measuring pyrometer
In this case, the value of the shunt R resistance on U T° must be adapted according to the setpoint and the desired
accuracy (10 mV per Degree).
Correspondence table
Voltage U T°
1 V
2 V
3 V
4 V
4.5 V
POWERDUCTION HEAT CONTROLLER
sif ON cancellation of thermocouple 2 measurement
if ON cancellation of thermocouple 1 measurement
offline
if ON activation of an OFFSET for the initial display at 100°C (button 5 has priority over
all the others) (do not use for a thermocouple measurement)
if ON and switch 5 OFF initial display at 0 (do not use for thermocouple measurement)
if ON activation of the footswitch connected to the REMOTE input
Temperature in Celsius
0°C
100°C
200°C
300°C
350°C
{
If both are OFF, the highest
measurements is displayed.
Temperature in Fahrenheit
32°F
210°F
390°F
570°F
660°F
EN
15