Brevi NIGEL 2/3 Instructions D'utilisation page 8

right height. Ensure that the headrest is adjusted to the right position so that the lower part of the headrest is at the same
level or slightly above the child's shoulder.
INSTALLATION
3 point belt (Universal)
1. Install the seat in the forward facing position.
2. Car safety belt through the base: place the car seat on the backseats, pull out the car seat belt entirely.
3. Safety belt to fix the car seat: the car seat belt must pass through the red belt guide of the child car seat headrest; lock the
car belt buckle, and tighten the belt properly.
4. Fasten the child: place the child on the seat. Adjust the height of the headrest according to the child's height. Warning: it
is important for the safety of the child to adjust the harness, so that there should be less than a finger gap between the car
safety belt and child.
5. If in doubt, consult either the child restraint manufacturer or the retailer.
GENERAL MAINTENANCE ADVICE
Remove the seat cover.
To fix the cover again on the seat carry out the steps in reverse order.
8