Inserting Several Rechargeable Batteries And Charging Them Manually - VOLTCRAFT 1403321 Mode D'emploi

d) Inserting several rechargeable batteries and charging them manually
• Insert the first rechargeable battery in a charging slot in the correct polarity. For this, pull the
sliding contact back and let the contact slide against the rechargeable battery. Observe the
polarity information in the charging slot and ensure good contact.
• After inserting each, the cell voltage of the rechargeable battery will be displayed in the
corresponding display for approx. 3 seconds. Then the pre-set charging current will be
displayed for 3 seconds.
• Within these 6 seconds, push the "CURRENT" (8) button to set the charging current for your
rechargeable battery. Every push will change the current value. After this setting, the current
display will continue to flash for another 10 seconds. The current value can be corrected
again during this time. To abbreviate the setting, you can push the "SLOT" (9) button to
confirm. Charging begins.
• Repeat this with up to 4 rechargeable batteries.
• After the end of charging, charging is ended automatically, or maintenance charging starts
for Ni-Cd and Ni-MH rechargeable batteries for each cell separately. The end of charging is
signalled with the display "FuLL".
• Remove the full rechargeable battery from the charging slot and disconnect the charger if no
rechargeable battery is in the charging slot anymore.
If you want to charge similar rechargeable batteries with similar charging currents, you
can set the current once for all occupied charging slots.
For this, push the "CURRENT" button after inserting each rechargeable battery. The
display will flash and the input time is extended to 10 seconds. Now insert the next
rechargeable battery during this time and push the "CURRENT" button again. Repeat
this until all rechargeable batteries have been inserted.
The "CURRENT" button can now be used to set the charging current for all inserted
rechargeable batteries.
The "MODE" button can also be used to set the rechargeable battery programme for all
charging slots in this setting phase (charge/discharge/refresh, etc.).
35