Axis Communications 211W Guide D'installation page 14

Page 14
Adjust the image and focus
To focus the AXIS 211W, follow the instructions below.
1. From the Basic Configuration page in the
setup tools, open the Focus adjustment
page.
2. Set the DC-Iris to Disabled and click Save.
3. Unscrew the zoom puller on the lens by
turning it anti-clockwise. Adjust the zoom
setting as required. Re-tighten the zoom
puller.
4. Unscrew the focus puller on the lens.
Adjust the focus as required. Re-tighten
the focus puller.
5. From the Focus adjustment page, set the
DC-Iris to Enabled and click Save.
Note:
The DC-Iris should always be disabled
while focusing the camera. This opens
the iris to its maximum, which gives the smallest depth of field and thus the best
conditions for correct focusing. When the focus is set with this method it will
then be maintained in any light conditions.
Accessing the AXIS 211W from the Internet
Once installed, your AXIS 211W is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic,
which is usually done on a specific port. Please refer to the documentation for your router
for further instructions. For more information on this and other topics, visit the Axis Support
Web at www.axis.com/techsup
AXIS 211W Installation Guide
Zoom puller
(Tele/wide)
Focus puller