Step 9: Install Water Line - Honeywell Home HE120 Instructions D'installation

STEP 9: INSTALL WATER LINE

CAUTION
Water Hazard.
Can result in water damage to property.
Properly secure water line along route to prevent
movement and provide support at compression nut
joints.
IMPORTANT
Be sure to check with your local building codes to
determine if the Plastic Water Tubing packaged
with the Humidifier is appropriate for your installa-
tion. (Some local building codes require 1/4 in.
copper tubing to be used.)
1. Place Brass Compression Nut over Plastic Water
Tubing. See Fig. 35.
BRASS COMPRESSION NUT
Fig. 35. Connecting plastic water line.
PLASTIC
COMPRESSION
RING
BRASS INSERT
M20176
HE120 BY-PASS DRUM HUMIDIFIER
2. Slide the Plastic Compression Sleeve over the Tub-
ing.
3. Install Brass Insert into end of Plastic Water Tubing.
NOTE: To prevent leaking, use Plastic Compression
Sleeve only with Plastic Tubing and Copper Com-
pression Sleeve only with copper tubing.
4. Insert the tubing into the saddle valve fitting.
5. Support the valve while tightening the Brass Com-
pression Nut with an 1/2 in. open-end or adjustable
wrench.
6. Route Plastic Water Tubing from saddle valve to
Humidifier Float Valve Fitting. Secure Plastic Water
Tubing along the route with Tube Retainers to pre-
vent movement.
7. Cut Plastic Water Tubing to length. (Do not cut tub-
ing too short.)
8. Repeat steps A through E to attach Tubing to Float
Valve Fitting.
15 69-1860EF—02