Publicité
Liens rapides
HC18A, HC22A, HC26A
Humidifier Pad
APPLICATION
The HC18A, HC22A, and HC26A Humidifier Pads replace
the humidifier pad in the Flow-Through Humidifiers or
Aprilaire® Humidifiers. The humidifier spreads water over
the humidifier pad, and when warm air blows over the
water-soaked area, vapor is generated. As the vapor
circulates through the house, the relative humidity rises.
INSTALLATION
CAUTION
Personal Injury or Equipment Hazard.
Can cause electrical shock or equipment
damage.
Disconnect power supply before installing or
servicing.
Turn off water supply.
IMPORTANT
Do not remove the powder from the new humidifier
pad. The powdery coating on the pad promotes
water dispersement.
1. Remove the humidifier cover. See Fig. 1.
2. Remove the humidifier pad assembly from the
humidifier by grasping the assembly and pulling it
toward you.
3. Pry open the frame at the corners until the Perfect-
Flo™ water distribution tray lifts off.
4. Gently pinch the water nozzle catches inward until
the water nozzle can be lifted off the tray.
5. Slide the humidifier pad out of the frame.
RECYCLE NOTICE
This humidifier pad is recyclable. After removing
the pad from the humidifier, wash off the powder
and recycle the pad with the aluminum recyclables.
IMPORTANT
Be careful not to punch the frame to prevent leak-
ing.
INSTALLATION INSTRUCTIONS
6. Carefully scrape any mineral deposits from the tray
and frame. Be sure nothing is blocking the frame
drain hole.
7. Reattach the water nozzle to the PerfectFlo™ water
distribution tray.
8. Insert the new humidifier pad into the frame.
IMPORTANT
Be sure the black line on the top of the humidifier
pad is facing up.
9. Replace the water distribution tray. Be sure all four
tabs are in place.
10. Place the humidifier pad assembly in the humidifier
housing and press until the assembly is completely
sealed. Be careful not to pinch or kink the water feed
tube.
WATER FEED NOZZLE
WATER DISTRIBUTION TRAY
HUMIDIFIER PAD
COVER
FRAME
Fig. 1. Humidifier components.
11. Replace the humidifier cover.
12. Turn on the power and water supply.
13. To verify the humidifier operation, refer to the
Owner's Guide Checkout Procedure section.
HUMIDIFIER
HOUSING
WATER
FEED
TUBE
M12371C
69-1576EF-02
Publicité
Manuels Connexes pour Honeywell Home HC18A
Sommaire des Matières pour Honeywell Home HC18A
- Page 1 6. Carefully scrape any mineral deposits from the tray and frame. Be sure nothing is blocking the frame drain hole. The HC18A, HC22A, and HC26A Humidifier Pads replace 7. Reattach the water nozzle to the PerfectFlo™ water the humidifier pad in the Flow-Through Humidifiers or distribution tray.
- Page 2 The Honeywell Home trademark is used under license from Honeywell International, Inc. This product is manufactured by Resideo Technologies, Inc. and its affiliates. Tous droits réservés. La marque de commerce Honeywell Home est utilisée avec l’autorisation d’Honeywell International, Inc. Ce produit est fabriqué par Resideo Technologies, Inc. et ses sociétés affiliées.
- Page 3 APPLICATION 6. Gratter soigneusement les dépôts de sédiments au fond du plateau et sur le cadre. S’assurer que rien ne Les écrans évaporateurs d’humidificateur HC18A, HC22A, bloque l’orifice de vidange. HC26A servent à remplacer ceux des humidificateurs à 7. Reposer le gicleur sur le plateau de distribution circulation directe ou ceux des humidificateurs Aprilaire®.
- Page 4 The Honeywell Home trademark is used under license from Honeywell International, Inc. This product is manufactured by Resideo Technologies, Inc. and its affiliates. Tous droits réservés. La marque de commerce Honeywell Home est utilisée avec l’autorisation d’Honeywell International, Inc. Ce produit est fabriqué par Resideo Technologies, Inc. et ses sociétés affiliées.