Atag Cube Manuel D'installation page 9

installing
Associating the zone
- Check that the thermostat is powered
up and properly hooked up
+
- Hold the " " key on the thermostat
down for 5 seconds (Fig. 14).
The display will alternate between the
software version and modification in-
dex.
+
- Hold the " " key on the thermostat
down for 5 seconds.
The display will show the parameter
"nr02" (Fig. 15).
- Press "OK" to enter the zone associa-
tion menu; the display will show the first
available zone.
+ -
- Press " " and " " to select the zone you
wish to associate (Fig. 16).
- Press 'OK' to confirm.
- Press "MODE" to return to the main
screen.
x 5s
Fig. 14
x 5s
Fig. 15
Fig. 16
GB - 9