Operating Mode - Atag Cube Manuel D'installation

operating mode

The system's operating mode can be set
to heating or cooling when the device is
connected to a product which supports
both modes (such as a heat pump).
Press the "MODE" key (Fig. 1) to display:
" ".
Press "MODE" again (Fig. 2) for 5 sec-
onds.
" " will display next to the key.
Now press the key to select the mode
(Fig. 3)
The display will show:
- "HEAT" heating
- "COOL" cooling.
Press the OK button to confirm the selec-
tion.
NOTE:
The heating/cooling mode selection ap-
plies to the entire system.
Fig. 1
Fig. 2
Fig. 3
x 5s
GB - 5