Atag Cube Manuel D'installation page 10

technical adjustments
TABLE OF PARAMETERS
ATAG Cube
- Hold "+" down for 5 seconds. The display will alternate between the software version and
modification index.
- Press "OK" to enter the settings menu.
- Press "+" and "-" to scroll through the parameters.
- Press "OK" button to select a parameter.
Par.
CF01
CF11
CF12
TABLE OF ERRORS
Error
Err – Ebus
- - -
Err
10 - GB
Description
Room temperature correction (range +/-5°C)
0: Display OFF after 10s
1: Display always on
0: Backlight off
1: Backlight OFF after 5s of inactivity
Cause
Zone association error: the
zone associated with the
device is already assigned
The thermostat is damaged
Solution
Check the installed thermostats. Assign a
different zone.
Replace it
Default
0°C
1
1