Light Oil Feeding; Priming And Adjustment Of Oil Pump - Ecoflam Multicalor 500.1 Mode D'emploi

Bruleurs mixte gaz + fuel

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

1 -

Inlet

2 -

Return

3 -

Bleed and pressure gauge port

4 -

Vacuum gauge port

5 -

Pressure adjustment

6 -

Nozzle outlet

7 -

Heater

WARNING: For a correct working of the pump, verify what follows:

Pump :

Oil temperature at the pump:

Maximum allowable pressures:

SUNTEC TA2C4

VERIFY:

- That piping system is perfectly sealed;

- That the use of hoses is avoided whenever is possible (use copper pipes preferably);

- That depression is not greater than 0,45 bar, to avoid pump's cavitation;

- That check valve is suitably designed for the duty;

The pump pressure is set at a value of 22-25 bar during the testing of burners. Before starting the burner, bleed the air

in the pump through the gauge port. Fill the piping with light-oil to facilitate the pump priming. Start the burner and

check the pump feeding pressure. In case the pump priming does not take place during the first prepurging, with a con-

sequent, subsequent lock-out of the burner, rearm the burner's lock-out to restart, by pushing the button on the control

box. If, after a successful pump priming, the burner locks-out after the prepurging, due to a fuel pressure drop in the

pump, rearm the burner's lock-out to restart the burner. Do never allow the pump working without light-oil for more

than three minutes.

Note: before starting the burner, check that the return pipe is open. An eventual obstruction could damage the

pump sealing device.