Skytec 150.343 Mode D'emploi page 4

If you wish to switch between MIDI and DMX, switch the unit off first and wait for 10 seconds. The
MODE switch must be set to ON prior to switching the unit on again.
To set the required channel and the
must be placed as indicated in the table below via the DIP switches 1 to 3. The MIDI channel (9 to 16)
is the added value of the switched on DIP switches plus 9.
(The values of the DIP switches are as follows: 1=1, 2=2, 3=4)
The numbering of the MIDI controller works in steps of 3 channels where the first of the three
controllers sets the brightness, the second the colour and the third the fader. The number is
determined according to following table. Please not that the values of the DIP switches differ.
Controller
(The values of the DIP switches are: 4=3, 5=6, 6=12, 7=24, 8=48, 9=96)
All manuals and user guides at all-guides.com
1 2 3 4 5 6 7 8 9 10
Midi DIP Switch
Channel 1 2 3 4 5 6 7 8 9
9 0 0 0
10 1 0 0
11 0 1 0
12 1 1 0
13 0 0 1
14 1 0 1
15 0 1 1
16 1 1 1
DIP Switch
Number 1 2 3 4 5 6 7 8 9
0 – 2 - - - 0 0 0 0 0 0
3 – 5 - - - 1 0 0 0 0 0
6 – 8 - - - 0 1 0 0 0 0
9 – 11 - - - 1 1 0 0 0 0
12 – 14 - - - 0 0 1 0 0 0
15 – 17 - - - 1 0 1 0 0 0
18 – 20 - - - 0 1 1 0 0 0
21 – 23 - - - 1 1 1 0 0 0
24 – 26 - - - 0 0 0 1 0 0
27 – 29 - - - 1 0 0 1 0 0
‫׃‬ ‫׃ ׃ ׃ ׃ ׃ ׃ ׃ ׃ ׃‬
‫׃‬ ‫׃ ׃ ׃ ׃ ׃ ׃ ׃ ׃ ׃‬
93 - 95 - - - 1 1 1 1 1 1
OFF
ON
controller number, the DIP switches
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -