Haier HBF1055TVE Guide De L'utilisateur page 23

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problems with clothes:
• Clothes are too wrinkled: This is due to improper sorting, overloading and
washing in too hot water repeatedly. Avoid overloading and resort your load.
Do not mix heavy clothes such as work clothes with light clothes such as
blouses, light shirts and delicate items. You may need to wash in warm or cold
water.
• Soap residue: Detergent may not be dissolving in water. Check water
temperature. Use less detergent.
• Spots or stains on your clothes: This is due to incorrect use of fabric softener.
You may need to read proper instructions on the detergent container and
follow proper directions for using the softener.
• Clothes are grayed or yellowed: This is due to not pouring enough detergent
for large loads. You may have to add more detergent to the load.
• Clothes are ripped & have holes/excessive wear & tear: This is due to sharp
objects such as pins and belt buckles left in pockets. You will need to remove
small loose sharp objects. Fasten belts, zippers, metal snaps etc.
Trouble messages: Judge the malfunctions from the door lock light.
Error 1:
The door lock light does not illuminate.
Cause:
Door is not properly shut.
Correction: Shut the door properly.
Error 2:
The door lock light flashes 2 times and stops for 4 seconds
repeatedly
Cause:
Drainage error, water not emptied within 4 minutes.
Correction: Clean the filter and check the drain hose for blockage. If error still
exists, please contact an authorized service personnel.
Error 3:
The door lock light flashes 5 times and stops for 4 seconds
repeatedly. Cause:
Correction: Make sure that tap is turned on, and water pressure is normal. If
problem still exists, please contact an authorized service personnel.
Error 4:
The door lock light flashes 6 times and stops for 4 seconds
repeatedly.
Cause:
Timing control damage.
Correction: Contact an authorized service personnel.
Error 5:
The door lock light flashes 7 times and stops for 4 seconds
repeatedly.
Cause:
Motor overheat protection or damage.
Correction: Contact an authorized service personnel.
Error 6:
The door lock light flashes 8 times and stops for 4 seconds
repeatedly.
Cause:
Water exceeds protective level.
Correction: Contact an authorized service personnel.
Water level not met in 8 minutes.
English
22

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wd-9999-53

Table des Matières