Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Headgear reassembly
Pixi Hints!
• You don't need to disassemble your Pixi headgear to wash it.
• The Velcro straps and plastic buckles have been color coded for ease of
assembly.
Headgear reassembly steps
1.
Lay the headgear and plastic buckles out on a flat surface as shown, ensuring the
lower headgear arms are facing up.
2.
Thread each light blue strap up and over the light blue buckle, then secure into
place.
3.
Thread each dark blue strap up and over the dark blue buckle, then secure into
place.
4.
Thread the Velcro only end of the lower headgear strap through the lower
headgear arm, then secure into place. There is no need to attach the quick release
clip to the headgear now.
Ensure that any Velcro or plastic parts are on the outer side of the mask, otherwise your
headgear may be incorrrectly assembled. The headgear is now ready for fitting. Refer to
the Set up illustrations in this guide.
Reassembly
Reassembly steps
1.
Insert each side of the cushion into the sockets of the mask frame. Ensure the
cushion is oriented correctly. The arrows on the cushion should be pointing up
towards the plug tether. The raised vented area of the cushion should also be
sitting up against the mask frame.
2.
Pull the arms of the cushion through until the collar of the cushion shoulder is
sitting against the mask frame.
3.
Replace the plug into the appropriate side of the cushion.
4.
Insert the combined elbow and air tubing into the other side of the cushion,
ensuring that it is fully inserted.
5.
Reattach the headgear. Refer to the Attaching the headgear illustrations in this
user guide.
5
Publicité
Table des Matières
