Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Set up
Determine which side of the cushion the air tubing will be located. Ideally this should be
the side that is closest to the device.
Pixi Hint! If the child has a preference for sleeping on a particular side, this
should be considered when determining the location of the device.
Changing the side of the air tubing
1.
To change the side of the air tubing, remove the plug from the cushion.
2.
Insert the combined elbow and air tubing until the cushion meets the ridge on
the elbow.
3.
Ensure the opposite side of the cushion is fully closed by securely inserting the
plug into the cushion opening.
Attaching the headgear
The mask frame has been designed to ensure the headgear is fitted correctly every time.
4.
Latch the lower headgear arm with the star onto the frame node with two stars,
so that the frame is nested between the plastic and the padding of the headgear.
5.
Gently pull the headgear arm into place until it clicks.
6.
Repeat steps 4-5 with the other side (without stars).
Set up is now complete and the mask is ready for fitting.
WARNING
•
Ensure that the nasal cushion does not block the nostrils at any time during
fitting or use.
•
Do not leave long lengths of air tubing around the top of the child's bed. It could
twist around the child's head or neck while sleeping.
Fitting
The fitting illustrations show the sequence for obtaining the best fit and comfort when
using the mask.
Pixi Hints!
• If fitting the mask for the first time, we recommend the child be sitting in an
upright position to ensure correct fit.
• To avoid possible anxiety by the child, ensure all parts of the mask frame
and headgear are kept clear from the eyes and eye area.
• The child will best adapt to therapy if the mask is correctly fitted before the
device is turned on.
2
Publicité
Table des Matières
