Remote Sensor; Sensor Data Transmission - Oregon Scientific Weather Home Thermo Plus Mode D'emploi

LoCATIoN
Clock area
Outdoor temperature area

REMoTE SENSoR

The main unit can collect data from up to 5 sensors.
To set up the sensor:
1. Open the battery compartment.
. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main
unit using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
1.5 m (5 ft)
MEANING
Main unit batteries low
Sensor batteries low
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures
below freezing.

SENSoR DATA TRANSMISSIoN

To search for a sensor:
• Press and hold
 seconds.
To auto-scan among sensors:
The main unit can search for the sensor(s)
automatically. The temperatures will be displayed
automatically in sequential order.
The sensor reception icon in the remote sensor
area shows the status:
ICoN DESCRIPTIoN
Main unit is searching for sensor(s).
A channel has been found.
The sensor cannot be found.
TIP The transmission range may vary depending on
many factors. You may need to place the sensor(s) in
different locations to get the best result(s).
5
and MoDE at the same time for