Ickle Bubba Moon Manuel D'instructions page 7

Assembly - Using the Harness
1.
Insert both shoulder
strap fasteners securely
into the loops located
on the side straps
To remove the harness during carrycot mode, place your hand through
the Velcro opening at the back of the carrycot and thread each of the
plastic tabs through the small gap in the wooden base and pull through
the front of the carrycot fabric. To reinstall, repeat the process in reverse,
and ensure that each harness belt is secured.
Assembly - Installing the Pram Hood
1.
Insert the
frame of the hood into
the corresponding re-
ceptors located on the
pram frame.
2.
Press the two side
straps into the centre
clasp until both sides are
clicked in securely.
Adjust each strap length
as required.
2.
Align the zip located
metal
on the rear side of the
hood to the zip found
on the
unit fabric and fasten.
carrycot/seat
v.02.20
3.
To undo the harness,
press the buckles in the
centre of the harness
and pull apart.
3.
To remove the hood,
unfasten the zip, then
press both of
hood connector
tons and pull the metal
upwards .
hood frame
the
but-
07