Indicator Lights - SW-Stahl S3300 Mode D'emploi

Tournevis a chocs sans fil 1/2", brushless, 18v

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

S3300

•

FORWARD/REVERSE LEVEL

WARNING : Always check the direction

of rotation before operation .

This determines the direction of

rotation of the chuck, ie . clockwise or

anti-clockwise .

To alter the direction of rotation stop

the drill then push the

selection lever to the left of right .

When the lever is in the "Forward"

position the chuck will rotate

clockwise . When the lever is in the

"Reverse" position the chuck will rotate anti-clockwise . Before

operation check that the level is set in the required position .

(Fig . 4)

WARNING : Use the reversing switch

only after the tool comes to a complete

stop . Changing the direction of rotation

before the tool stops may damage the

tool.

When not operating the tool, always set

the reversing switch lever to the neutral

position .

•

TRIGGER

To start the tool, simply press the

trigger . Tool speed is increased

by increasing pressure on the

trigger . Release the trigger to

stop . (Fig . 5)

When the trigger is de pressed

the chuck will rotate (provided

the forward/ reverse level is set in the forward or reverse

position) . The trigger can be locked in the OFF position .

This helps reduce the possibility of accidental starting when

not in use . To lock trigger, place selection lever in the

centre position .

•

HOW TO OPERATE THE IMPACT POWER

SELECTION

The impact power selection

button is used to adjust the

torque, rotation speed (RPM),

and impact speed (IPM) for

different application . Please pay

attention . Power modes are not

able to be switched when tool

being run .

Before you selecting the mode on

the top pad, please click out the

trigger to let electric current

through the pad for your

selection.

L/M/H three modes only be selected at forward

rotation, L/M/H three modes and

mode) are selected at reversed rotation . When the

Fig. 4

Trigger

Fig. 5

Light

Button

Fig. 6A

Fig. 6B

mode (R

SW-Stahl GmbH

An der Hasenjagd 3

D-42897 Remscheid

letter you press is lighted, the tool is ready to work .

(Fig . 6A)

The lighted alphabetic symbols during operation are

shown as battery capacity the tool remains . The

lighted alphabetic when trigger released is shown

what speed mode the tool stays .

10. When 4 lights flash at once it symbols either the tool

or the battery failed . Please check carefully .

(Fig . 6B)