Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
S3300
S3300
• BATTERY PACK PREPARATION FOR
RECYCLING
WARNING : Upon removal, cover the
battery pack's terminals with heavy duty
adhesive tape . Do not attempt to destroy
or disassemble the battery pack or
remove any of ist components . Do not
touch both terminals with metal objects
and body parts, as short- circuit may
result . Keep away from children . Failure
to comply with these warnings could
result in fire and/or serious injury.
PRECAUTIONS ON USING YOUR
CORDLESS TOOL
This product contains Lithium Ion batteries which must be
disposed of properly .
1 . Be aware that this tool is always in an operating con-
dition, because it does not have to be plugged into an
electrical outlet .
2 . Fully charge the battery for better operation .
3 . Be sure the battery is snapped in place .
4 . When not in use, lock the switch .
5 . When operating at a high place, be aware of things below
and around you .
6 . This unit features the overload protection design . When
the unit overload or stall, the power would be cut-off
automatically . This will protect the motor, switch and
battery .
7 . This unit features a battery temperature detective sensor .
If the battery exceeds the safety working temperature, the
unit would shut-off automatically . Once the temperature
dropped back to the safe temperature zone, the unit
would function normally again .
8 . This unit features a battery over-discharge protection
system which can prolong the battery's lifespan .
OPERATION INFORMATION
WARNING : Before attempting to use
any tool, make sure you are familiar with
all operating features and safety
requirements .
SW-Stahl GmbH
SW-Stahl GmbH
An der Hasenjagd 3
An der Hasenjagd 3
D-42897 Remscheid
D-42897 Remscheid
A
B
E
C
F
H
J
K
A . Anvil
B . LED Light
C . Trigger
D . Forward/Reverse level
E . 4 Stage Impact Power
Selection and Battery
Capacity Indicator Light
• INSTALLING OR REMOVING BATTERY
PACK
1.
Hold the tool and the battery
pack firmly when installing or
removing battery pack .
Failure to hold the tool and
the battery pack firmly may
cause them to slip off your
hands and result in damage
to the tool and battery pack
and a personal injury.
2.
Always switch off the tool before installing or removing of
the battery pack
3.
To remove battery pack, press the battery clip, and pull
out . To install the battery pack, align the tongue on the
battery pack with the groove in the housing and slip it
into place . Always insert it all the way until it locks in
place with a little click . If not, it may accidentally fall out
of the tool, causing injury to you or someone around you .
(Fig . 1)
Tel. +49 (0) 2191 / 46438-0
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
E-Mail: info@swstahl.de
S 3 3 0 0
D
G
I
F 4 Stage impact power
selection button
G Belt Hook
H Battery Clip
I
Battery Pack
J Charger
K Battery fuel indicator
Fig. 1
www.swstahl.de
www.swstahl.de
15
Publicité
Table des Matières
