HP PHOTOSMART C410 Serie Guide Rapide page 9

Networked printer setup and use
Changing the type of computer connection
Changing your connection from USB to wireless
If you initially set up your printer using a USB connection to your computer, you can switch the
connection to a wireless network connection by following these steps.
USB
to
Wireless
To change from USB to wireless connection:
1. Click Start, click All Programs, click HP,
2. Follow the instructions on the displayed
Changing your connection from USB to wired (Ethernet)
If you initially set up your printer using a USB connection to your computer, you can switch the
USB
connection to a wired (Ethernet) network connection. In the onscreen Help, see Finish setting up
to
the HP Photosmart > Add the HP Photosmart to a network > Wired (Ethernet) network.
Wired
Troubleshooting for a wireless printer setup
If your printer
is not found
Check that your printer is connected to your network
during software
Run a Wireless Network Test to check that your printer is on the network. To do this:
installation...
1. On the HP Photosmart front panel, press the Wireless button to display the Wireless menu on
2. Select Run Wireless Network Test on the display.
3. The Wireless Network Test Report is automatically printed.
If your printer is not connected to the network:
1. Press the Wireless button to open the Wireless menu on the printer display. Select Wireless
2. Follow the instructions on the screen.
For additional help with setting up a wireless connection, go to the Wireless Printing Center site:
www.hp.com/go/wirelessprinting.
Windows
click Photosmart Prem C410 series, then
click USB to Wireless. Keep your USB cable
connected until prompted to disconnect it.
screens.
• Click Next to move from one screen to
the next.
• Click Help to get additional
information about what is required on
that screen.
the printer display.
• Check the top of the report to see if something failed during the test.
• See the Diagnostics Summary for all tests that were performed, and whether or not your
printer passed.
• Find out the Network Name (SSID), Hardware Address (MAC), and IP Address. See the
Configuration Summary for these details.
Settings, then Wireless Setup Wizard on the display.
Mac
To change from USB to wireless connection:
1. On the HP Photosmart front panel, press
the Wireless button to display the Wireless
menu on the printer display.
2. Select Wireless Settings, then Wireless
Setup Wizard on the display.
3. Follow the steps in the Wireless Setup
Wizard to connect the printer.
4. To add the printer, go to System
Preferences, select Print & Fax, then click
the + button. Select your printer from the
list.
9