Solving Problems - Montiss TYPHOON CVC5758M Mode D'emploi

All manuals and user guides at all-guides.com
5. After cleaning, place the filter back in the correct position.
6. Replace the filter cover.
Cleaning the device
1. Switch off the device before cleaning it.
2. Clean the device with a damp cloth and some detergent if necessary. Dry thoroughly.
Note: never use abrasives, bleaching agents or steel wool to clean the device. This could
cause damage to the material.
Storage
Make sure that the device and the attachments are completely clean and dry before you store
them.
SOLVING PROBLEMS
Problem
Device does not work
Device has no or very weak
suction power
Dust is coming from the
device
Power cable cannot be pulled
out
Power cable is not fully
wound
26
Possible cause
Plug is not properly plugged in
the wall socket
Dust tank is not properly
assembled
Dust tank is full
One or more filters are
clogged up
Hose or hose outlet is clogged
up
Dust tank is not properly
assembled
Hose is not properly
assembled
Dust tank is full
Power cable is entangled
Power cable is entangled
Possible solution
Put the plug in the wall socket
again
Re‐assemble the dust tank
Empty the dust tank
Clean the filters
Switch the device off and take
the plug from the wall socket.
Check for blockages
Re‐assemble the dust tank
Assemble the hose in the hose
outlet
Empty the dust tank
Carefully pull the power cable
in and out a number of times
and press the button to wind
up the cable
Carefully pull the power cable
out some length and press the
button to wind up the cable