Montiss TYPHOON CVC5758M Mode D'emploi page 24

All manuals and user guides at all-guides.com
Note: do not use heating sources (blow‐dryer, heating, etc.) to dry the filters and do not put
the filters back into the device until they are completely dry.
5. Clean the dust container with a damp cloth.
6. Place the lid on the dust container. Please note the marks on the dust container: the right
arrow should be in line with the small line on the left side of the lid.
7. Put the dust container back onto the device.
Cleaning the motor filter
Clean this filter after each use.
1. Press the button to remove the dust container from the unit.
2. Open the air‐inlet plate below the dust container by releasing the clip.
3. Take out the filter and the filter tray.
4. Clean this filter and filter tray separately. Both parts can be cleaned by tapping them against
the side of a dust bin. Remove the dirt and dust.
5. Replace the filter tray and the filter.
6. Replace the air‐inlet plate. Put both pins on the upper side of the plate into place, and push
the air‐inlet plate into position. Make sure the plate locks into position.
24