Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OE 6047
HOT AIR GUN 50-650°C
ACCESSORIES
Description
Protective nozzle
Welding nozzle
Reduction nozzle
Reflective nozzle
Scraper
Warning
• make sure that the tool is switched off and the nozzle has cooled down.
• falling down nozzle can set an object on fire. Nozzles must be mounted firmly and secure on the unit.
• touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle, allow the unit to
cool down completely or use a suitable tool.
• a hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
• an incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only original
nozzles according to the table that are suitable for your unit.
INSTRUCTIONS
• always observe the safety instructions and applicable regulations.
• use only one hand to hold the tool, do not place your other hand over the air vents
Prior to operation :
• mount the correct accessory for the application.
• set the desired air temperature
Switching on and off
• to switch the tool on, set the on/off switch to position 1/2. Some smoke may be emitted after switching on;
this does not indicate a problem.
• to switch the tool off, adjust the lowest temperature to cool off, then set the on/off switch to position 0.
Let the tool cool down before moving or storing it.
Purpose
Protection windows when stripping frames
Dying, thawing (heat spread over wider area)
Welding, shrink sleeving (heat concentrated over small area)
Soldering pipes
Stripping paint and varnish
Publicité
Table des Matières
