Adjustment - CLAS OE 6047 Mode D'emploi

OE 6047
HOT AIR GUN 50-650°C

ADJUSTMENT

The air temperature can be adjusted to suit a wide range of applications. The table below suggests settings
for different applications
Adjustment
1
2
If you are not sure about the correct setting, start with a low temperature setting and gradually increase the
temperature until you achieve optimum results.
Application
Drying paint, varnish color shade samples, filler, adhesives, construction
joints and stucco forms
Drying wet timbor prior to filling
Removing stickers
Joining adhesives-Large-surface gluing with contact adhesives, activation
of pressure-sensitive adhesives, acceleration of bonding processes,
releasing of bonding points as well as releasing or bonding of edge band
or veneer.
Waxing and de-waxing
Shrinking PVC wrapping and insulation tubes
Defrosting of icy stairs and steps, door locks, trunk lids, car doors or water
pipes, as well as for defrosting refrigerators and ice boxes
Welding of thermoplastic polymer, flooring materials of PVC and linoleum,
PVC-coated fabric, tarpaulins and foils
Bending plastic pipes and sheets
Soldering plumbing joints, tin, special silver solder, SMD elements, cable
lugs
Loosening rusted or tightly fastened nuts and bolts
Removing old and even thick coatings of oil paint, lacquer, varnish and
synthetic plaster
Disinfection-With hot air of 600°C, you can quickly rid animal sties/stables
of bacteria .Woodworm infestation can be controlled (Caution: Danger of
fire! Do not heat up the wooden surface excessively).