GoodHome bamia GHIHAC60 Installation page 130

EN Safety
PL Bezpieczeństwo
EN Troubleshooting
Problem
The cooktop cannot be
turned on.
The touch controls are
unresponsive.
The touch controls are difficult
to operate.
Some pans make crackling or
clicking noises.
The induction hob makes a low
humming noise when used on a
high heat setting.
Fan noise coming from the
induction hob.
Pan does not heat up and it does
not appear in the display.
Error Code
ER03 Water or pan on the Control Panel
E1 Hob has overheated
E2 Hob has overheated
E3 Abnormal power supply detected
(too high)
E4 Abnormal power supply detected
(too low)
FR Sécurité
RO Siguranță
Possible cause
No power.
The controls are locked.
There may be a slight film of
water over the controls or
you may be using the tip of
your finger when touching the
controls.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
This is caused by the technology
of induction cooking.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue to
run even after you've turned the
induction hob off.
The induction hob cannot detect
the pan because it is not suitable
for induction cooking.
The induction hob cannot detect
the pan because it is too small for
the cooking zone or not properly
centred on it.
Error Message
Solution
Make sure the cooktop is
connected to the power supply
and that it is switched on. Check
the household fuse for the
appliance.
Check whether there is a power
cut by trying other electric
appliances.
Unlock the controls
( Safety mode (child lock).
Make sure the touch control area
is dry. Use the ball of your finger
when touching the controls.
This is normal for cookware and
does not indicate a fault.
This is normal, but the noise
should quieten down or
disappear completely when you
decrease the heat setting.
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Use cookware suitable for
induction cooking. Centre the
pan and make sure that its base
matches the size of the cooking
zone.
( Choosing the right cookware)
Solution
Clean the Control Panel or move the
pan
Allow to cool and restart after 30
minutes
Allow to cool and restart after 30
minutes
Ensure the correct power supply is
being used
Ensure the correct power supply is
being used
17