Frame; Side Frame; Folding System; Seat Height Adjustment - Invacare Action 1 NG Manuel D'utilisation

Note : the armrests are mounted in pairs on the wheelchair ;
whenever you remove them, remember that you have a right
and a left side !
Never lift the wheelchair by the armrests !
Keep your fingers away from movable parts during folding,
disassembling or adjusting to prevent injuries !

2.2. Frame

2.2.1 Side frame

The side frames are designed to accommodate fixation of
the front and rear wheels. No adjustment is required on side
frames.
EN22

2.2.2 Folding system

It consists of two cross-bars which integrate the seat rails.
To fold and unfold your wheelchair, see chapter A " General "
paragraph 2.1. No adjustment is required on folding system.
2.2.3 Seat Height adjustment (photos 13 & 14)
The Invacare Action 1 NG allows 2 seat heights 50 cm (A) or
® ®
45 cm (B), always delivered with 50 cm height.
To achieved 45 cm seat height, insert rear wheel quick release
axle (see chapter 2.3.3 for detailed operation) into the chassis
bearing (B).
Loosen the front wheel bolt (6 mm Allen key), extract the nut
from A and insert into B, firmly tighten the bolt.
The above information is given to the user for
information only.
Any wheels position and/or angle fork adjustments to
the set up of your wheelchair should only be performed
at the direction of a competent person who has fully risk
assessed the implication of any changes to the wheelchair
configuration. Please consult your dealer.
A 13
B
A
14