Led Indicators - Axis M1011 Guide D'installation

AXIS M1011/M1011-W/M1031-W Installation Guide
Unit connectors
Network connector - RJ-45 Ethernet connector. Shielded cables recommended.
Power connector - Mini DC connector 5.0-5.1V DC, Max 1.5A. Center pin +.

LED indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Power Green
Amber
Wireless Unlit
Green
Red
AXIS M1031-W only
AXIS M1031-W is equipped with the following:
PIR sensor - a passive infrared sensor that measures infrared light from passing objects in its field
of view. If configured to do so, the camera can automatically switch on the light when triggered by
the PIR sensor. Sensitivity range up to 5m (16ft).
Light - the white illumination LED can be configured to be triggered by the PIR sensor or via the
web pages under Setup > Live View Config > Light buttons. Note that the light is designed for
temporary use and should not be permanently lit.
Microphone/ speaker for half duplex audio.
For more information, see the AXIS M1011/M1011-W/M1031-W User's Manual located on the Axis
web site at www.axis.com or on the Axis Network Video Product CD.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Steady for connection to 10 Mbit/s network. Flashes for network activity.
No network connection.
Steady green for normal operation.
Note: The Status LED can be configured to be unlit during normal operation, or to
flash only when the camera is accessed. To configure, go to Setup > System
Options > LED. See the online help files for more information.
Steady during startup, during reset to factory default or when restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
Wired mode.
Steady for connection to a wireless network. Flashes for network activity.
Steady for no wireless network connection. Flashes when scanning for wireless
networks.
Page 15