Led Indicators - Axis Q60 Serie Guide D'installation

AXIS Q60 Series

LED Indicators

LED
Status
Midspan LED Indicators
LED
Port
AC
Connectors
For specifications and operating conditions, see page 17.
Network connector - RJ45 Ethernet connector. Supports Power over Ethernet Plus (PoE+) IEEE
802.3at. Use the supplied midspan.
NOTICE
NOTICE NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the midspan shall be shielded (STP) and intended for their specific use. Make
sure that the midspan is properly grounded. For information about regulatory requirements,
see Regulatory Information, on page 2.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording
with removable storage.
Color Indication
Unlit Connection and normal operation
Amber Steady during startup. Flashes during firmware upgrade.
Amber/red Flashes amber/red if network connection is unavailable
or lost.
Red Flashes red for firmware upgrade failure.
Green Shows steady green for 10 seconds for normal operation
after restart.
Indication
Color
Unlit No camera connected.
Green Steady when camera connected, normal operation.
Green, flashing Slow flash when overcurrent or short circuit condition
on the port.
Green, flashing Fast flash when input voltage is out of range or other
internal error.
Green Steady when AC power input connected.
13