Axis M1011 Guide D'installation page 11

AXIS M1011/M1011-W/M1031-W Installation Guide
Configure the wireless connection
AXIS M1011-W/M1031-W is temporarily connected to the wired network to allow configuration of
the camera's wireless settings before connecting to the wireless network. Configuring the camera
using an unsecured wireless connection is not recommended, as passphrases and keys are sent in
plain text.
Note:
For even greater security, use HTTPS. Once the camera has been connected to the wired network, go
to Setup > System Options > Security > HTTPS and refer to the camera's online help for
instructions.
Status of Wireless Networks
Go to Setup > Basic Setup > Wireless in the camera's internal web pages.
This list is the result of a network scan. The network the AXIS M1011-W/M1031-W is currently
linked to is shown in blue. A network using unsupported security is shown in grey. The following
information is provided:
SSID - The name of a wireless network (or ad-hoc device).
•
Mode - An Access Point (Master) or Ad-Hoc device.
•
• Security - Shows which type of security the network uses. See below for the supported
security types.
• Channel - Shows the wireless channel currently in use.
• Signal strength - Shows the signal strength.
• Bit rate - The current bit rate in Mbit/s. This is only shown for the access point currently in
use.
Note:
Access points with a disabled SSID Broadcast will not appear unless the SSID is manually
entered.
Page 11