Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. PREPARE HOOD
1. From inside the hood, disconnect the blower.
2. Remove the electrical box cover retaining screw. Set cover and screw aside.
3. Turn the hood over and remove blower box 8 retaining screws (only 4 out of
8 screws illustrated at right). Set hood and screws aside.
4. Lift flap located on top right hand corner of blower box (1) to ease wire clamp
installation (included). Install wire clamp and push flap back in place. Secure
flap to blower box (2) using 1 no. 8 x 3/8" quadrex screw.
NOTE: Install wire clamp diagonally (as illustrated in image 2), otherwise it will
be difficult to tighten its screws once the blower box is attached to the
angle brackets.
5. Attach the adapter/damper to the blower box using 4 no. 8 x 3/8" quadrex
screws (included). Remove tape on damper.
(ALL MODELS)
HE0062
HD0425
1
HO0188
HJ0066
8
HE0063
E
LECTRICAL COMPARTMENT
RETAINING SCREW
S
CREW LOCATIONS
2
Publicité
Table des Matières
