Witter VW64U Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Tube
D 2 Sidearms
EP 1 Electrical Plate (ZEP3)
E 8 M10 x 40 x 1.5mm Bolts (10.9 Grade) , 2 Nyloc Nuts, Lock Washers, 6 Large Flat Washers (30mm O.D.)
and Special Nut Retainers with Square Nuts
SC 1 Safety chain bracket (ZSCP5)
For use with
VW64Q Detachable neck option – ZQ3013. Please refer to ZQ fitting instructions for installation
FITTING
1. Remove bumper (Torx head screws around each wheel arch, along lower edge of rear panel). Remove bumper
cross beam from vehicle and discard (or retain for fitment when towbar is removed).Refit Bolts to prevent
ingress of water.
2. Assemble Special Cage Nuts as shown (PAGE 2) and insert into forward hole of Sidearm (D) and Forward hole
of Crossbar (A).
3. Insert Sidearms (D) inside chassis and loosely secure using forward Bolts (E) at existing holes (covered in tape).
4. Loosely attach Cross Bar (A) to Sidearms (D) using Bolts (E). Fully tighten all Bolts. DO NOT OVER TIGHTEN!
5. Attach neck assembly (upper most holes) with Electrical Plate (EP) and safety Chain bracket (SC) .Fully Tighten
Bolts.
6. Replace lower skirt and refit Bumper.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 70 Nm (10.9), M12 - 80 Nm, M14 - 130 Nm, M16 -
200
For use with bumper lower skirt with
Audi/Volkswagen with vehicle ID for parts
#NAME?
W0001VW64Q-FIT$010909020000
DETACHABLE TOWBAR
For Golf MK 6
removable panel – contact
VW64U