Witter VW63A Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Tube
D 2 Sidearms
EP 1 Electrical Plate (ZEP35)
E 4 M12 x 40 x 1.75mm Bolts, Lock Washers, 4 Large Flat Washers (30mm O.D.) and Special Nut Retainers
with Square Nuts
F 4 M12 x 40 x 1.75mm Bolt and Nyloc Nut
CB 2 M16 x 50 x 2.0mm Bolt, Nut and Lock Washers
FITTING
1. Remove bumper (Torx head screws around each wheel arch, along lower edge of rear panel). Remove bumper
cross beam from vehicle and discard (or retain for fitment when towbar is removed).Refit Bolts to prevent
ingress of water.
2. Assemble Special Cage Nuts as shown below and insert into forward hole of Sidearm (D) and Forward hole of
Crossbar (A).
3. Insert Sidearms (D) inside chassis and loosely secure using forward Bolts (E) at existing holes (covered in tape).
4. Loosely attach Cross Bar (A) to Sidearms (D) using Bolts (E) and (F). (Exhaust heat shield will require bending
forward slightly)
5. Fully tighten all Bolts.
6. Refit Bumper.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
W0001VW63A-FIT$0111031400002Ä
W0001VW63A-FIT$011103140000
TOWBAR
VW63A
For Golf MK 6