FITFIU FITNESS HSM-MT20 Manuel D'utilisation page 54

STEP 6.
Attach the upper and lower (with tube padding) accessory bar rails to the tabs (A) on the handle columns using 4
M8x40 screws (13) and nuts (5). Tighten the screws (rotate right) using the Allen key.
13
11
5
A
10 12
STEP 7.
Slide the tube joint covers toward the handle columns so that the joint is fully
covered.
STEP 8.
Bring the accessory bar (14) into position, with the dumbell hooks facing
11
upward, behind the centres of the accessory bar rails.
STEP 9.
Attach the accessory bar to the upper and lower accessory bar rails using 2
M8x55 screws (15) and nuts (5). Tighten the screws (rotate right) using the
14
Allen key.
STEP 10.
Slide the 2 remaining pieces of tube padding (11) over the horizontal accessory
bar tubes.
5
15
The machine should resemble the image below and is ready for use.
54