Witter DW14C Instructions De Montage

MATERIALS
A 1 Cross Bar
C 1 Centre Strut with European facing to 94/20/EC A50-1
D 2 Spreader Plates with captive bolts
D1 6 M12 x 1.75mm Nuts, Lock Washers and Large Flat Washers (40mm O.D.)
E 1 Left Hand Side Arm
F 1 Right Hand Side Arm
G 4 M12 x 35 x 1.75mm Bolts, Lock Washers and 2 Nuts
H 2 M16 x 40 x 2.0mm Bolts, Nuts and Lock Washers
CB 2 M16 x 50 x 2.0mm Coupling Bolts, Nuts and Lock Washers
BC 2 M16 Bolt Caps
Z 1 ZEP35 Electrical plate (not shown)
FITTING
1. Remove bumper (tip screws, 2 bolts along bumper edge each side (behind trim panels), 8 bumper beam nuts (6
under vehicle and 2 behind the boot trim), 6 screws along top edge). Note: Disconnect fog light wiring.
2. Remove bumper packing from bumper. For vehicles with foam inner, remove entire foam section and hand to
customer for refitting when bar is removed, Vehicles with plastic inner, remove foam section next to fixings as
shown below. Note: Care must be taken to avoid damage to fog light wires.
3. Cut open ends of the chassis (Drill the 4 dimples and cut between them). Remove rear exhaust hangers and lower
heat shield.
4. Locate rear most mounting point in bottom face of chassis rail (92mm rearward of middle mounting point) and drill out
existing 10mm hole to suit M12 bolt. Note: The 2 forward most holes are existing holes and do not require enlarging.
5. Insert Side Arms (E) and (F) into chassis. Slide Spreader Plates with captive bolts (D) into Side Arms (E) and (F) and
drop bolts down through holes, loosely attach with Nuts (D1).
6. Loosely attach Cross Bar (A) to Side Arms (E) and (F) using Bolts (G). Tighten all bolts. Cut heat shield to clear Bolts
(D) and re-fit. Re-mount exhaust.
7. Re-fit bumper. (For bumpers with foam inner, use existing plastic bumper fixings (J) through tabs on crossbar. For
bumpers with plastic inner refit may require tabs to be slightly deformed in order to refit bumper. Attach Centre Strut (C) to
Cross Bar (A) using Bolts (H). Tighten bolts.
Note: This towbar must be used with either a Witter Towball (part number Z1) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm , M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
µW0001DW14C-FIT$011104130000ÎÄ
W0001DW14C-FIT$011104130000
For DAEWOO TACUMA / REZZO
witter-towbars.co.uk
DW14C
TOWBAR
2000-
Issue 1