Atag KA2111DC Notice D'utilisation page 139

setting up your side-by-side
refrigerator refrigerator
Connecting the water line to the refrigerator
1. Remove the cap from water line on the unit and insert compression nut to the water line on the unit
after disassembling from provided water line.
2. Connect both water line from the unit and water line provided kit.
3. Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in these places should be examined
CAUTION
except the retail price includes
installation cost.
Installer for the installation if needed.
Installing the water filter.
1. Remove the water filter from the box and put a replacement
indicator sticker on the filter as shown.
future. For example, if you install the water filter in March,
the filter. Normally filter life is about 6 months.
3. Next, remove the fixed cap by turning it counter clockwise.
Keep the cap in a safe place for use if you choose not to use a
filter.
position and insert the filter into the filter housing.
5. Slowly turn the water filter clockwise 90º to align
with the indication mark on the cover, locking the
filter in position. Make sure that the indicator is
lined up with the "lock" position. Remember, do
not over-tighten.
If your model contains wine shelf, you should
remove the wine shelf before installing water
filters.
Sticker r r r
(Month indication)
Separation
Align the indication
of red cap
mark with lock position
3
Cover filter
_19
setting up