Atag KA2111DC Notice D'utilisation page 142

Removing any residual matter inside the water supply line after installing
filter.
1. Turn ON the main water supply & turn OFF the valve to the
water supply line.
2. Run water through the dispenser until the water runs clear
air from the lines.
4. Open the refrigerator door and make sure there are no water
leaks coming from the water filter.
into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray. (Optional)
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
1
22_
setting up
Ice maker
Feeler Arm
Check the water level
Test button
2