Technical Data; Before The First Use; Assemble The Stand - Cloer 6750 Notice D'utilisation

Technical Data

type volt
6750 220-240

Before the first use

Read these operating instructions
carefully before using the appliance
for the first time.
• Remove all packaging parts and, if applicable, sti-
ckers, not the identification plate.
• Before using the first time, clean the grilling surface
EN
by means of a soft cloth.
EC Label / Safety information
The appliance meets the requirements
of the applicable EC directives.
ATTENTION! Always unplug
the appliance when not in use
and before cleaning.
ATTENTION! Grilling surface gets
extremely hot in operation. There is
the danger of burns and fire! Only
touch the grill or the grill plate at the
heat-isolated handles.
• Never cover the grilling surface with aluminium foil.
Do not put saucepans, pans or aluminium bowls on
it, as the heat development can cause deterioration
of the non-stick coating.
• Never put baking paper and inflammable mate-
rials on the grilling surface. The immense heat can
cause fire.
• Never let the Barbecue Grill unattended while in ope-
ration.
• During the very first heating up the appliance can
cause slight smoke. After some minutes, however,
smoking will stop again.
ATTENTION! Even at the lowest
setting of the thermostat (level 1 or
lower) the appliance is already in
operation. Unplug the power plug to
switch off the appliance completely.
Operating instructions
• Your grill has an integrated heating integrated in the
die-cast plate of the grilling surface. It provides for a
constant and good heat distribution and healthy pre-
paration of your grilling goods.
• Due to the inside heating there is no offensive smell
and smoke because of dripping down and burning fat.
• Your Barbecue Grill is provided with a non-stick coa-
ting, avoiding sticking of grilling goods and facilita-
ting cleaning.
8
• The infinitely variable thermostat at the connector plug
hz watt
• Fat and juices developing during cooking are collec-
50 2000
• Put the Barbecue Grill on a dry, non-slip and even sur-
• Put spray guard on the appliance
• Push the fat collecting pan in the support bar below
• First of all, put connector plug in the lateral socket of
• Choose any heat level between 1 – 5 and so adapt
• Wait some minutes until the grilling surface is hot.
• Now you can put on the grilling goods.
• The even surface is appropriate for grilling vegeta-
• Do not use the grilling goods by means of tongs or forks
• Please exclusively use grill cutlery of wood or heat-re-
• Do not use aluminium grill pan at the grilling surface
• Turn the stand platform up-side-down to assemble
• Turn over the stand and hang the basket onto the
• ATTENTION! When using the grill with the stand, ensu-
serves for adapting the grilling temperature to the re-
spective grilling goods or for keeping meals warm.
ted in the removable fat collecting pan.
Start-up
face or on the stand provided. It has to stand stable
and safe as well.
the appliance.
the appliance (as far as it will go!) and then the power
plug in the wall socket. Now the appliance is already
in operation.
the temperatures to the grilling goods. At lowest
setting (level 1 and below) you can keep the grilled
meals warm.
bles and the waved surface for grilling meat.
of metal as this will damage the non-stick coating.
sistant plastics!
as this will cause a dangerous development of heat.
Set up
Parts of the stand:
1. Stand platform 2. Legs
3. Cross bar 4. Cross bar clip
5. Basket

Assemble the stand

the stand as shown below.
side bars of the legs.
re that the feet of the grill sit fully into the recess of the
stand platform and ensure that the grill stands even.